wimapply exit with error code 68
Posted: Wed Sep 14, 2022 8:15 am
Hello All,
im currently stuck with a challenge to apply .wim image to ntfs partition of a SSD on a Linux environment. i successfully installed wimlib and run following command to apply wim image to a ntfs partition : "wimapply /path/to/wim/file /dev/sdb1".
The error message i received was as follows : "wimlib was compiled without support for NTFS-3G, so it cannot apply a wim image directly to an NTFS volume. Exiting with error code 68 : the requested operation is not supported"
i confirmed using "df -T" command that my SSD's ntfs partition is not mounted anywhere. I also confirmed that my linux machine has NTFS-3G (2021.8.22) installed. Since the error stated that the wimlib was compiled without NTFS-3G, i downloaded the wimlib source code and compiled on my linux environment. during the ./configure step, i noticed that NTFS-3G was checked as below. However, i still get the exact same error when i try to apply wim image to the SSD ntfs partition. Please advise how to get around this
im currently stuck with a challenge to apply .wim image to ntfs partition of a SSD on a Linux environment. i successfully installed wimlib and run following command to apply wim image to a ntfs partition : "wimapply /path/to/wim/file /dev/sdb1".
The error message i received was as follows : "wimlib was compiled without support for NTFS-3G, so it cannot apply a wim image directly to an NTFS volume. Exiting with error code 68 : the requested operation is not supported"
i confirmed using "df -T" command that my SSD's ntfs partition is not mounted anywhere. I also confirmed that my linux machine has NTFS-3G (2021.8.22) installed. Since the error stated that the wimlib was compiled without NTFS-3G, i downloaded the wimlib source code and compiled on my linux environment. during the ./configure step, i noticed that NTFS-3G was checked as below. However, i still get the exact same error when i try to apply wim image to the SSD ntfs partition. Please advise how to get around this
Code: Select all
checking pkg-config is at least version 0.9.0... yes
checking for LIBXML2... yes
checking whether to include support for ntfs-3g... yes
checking for LIBNTFS_3G... yes
checking whether to include support for mounting WIMs... yes
checking for LIBFUSE... yes